![]() I'm thinking that the EDU is bad - is there anything else that can be done prior to going down the route of replacing the EDU? I tried resetting the EDU, but I'm expecting the unit to blink after holding down the buttons for 8 seconds, and it does not.it seems dead. I used a multi-meter, and checked power at the harness, and it's getting the expected voltage and amperage (so it's getting power to the harness). It doesn't respond to RA2 commands, or to direct presses of the buttons on the drive. No need to point or aim the remote, RTS is omnidirectional and operates reliably at a distance of 20 feet (up to 65 feet under optimal conditions). I don't even get lights when it powers on. Simply press a button on a remote control or wireless wall switch to send out a radio wave signal to move motorized Insolroll interior or Oasis outdoor shades with ease. There's zero lights on the wireless receiver, and there's no lights on the EDU. Users can adjust lights and shades to levels that meet their activities. The Pico can be mounted on the wall or on a table with a pedestal, putting control where you want it without the need to pull wires. Our automated window treatments not only add the perfect finishing touch to your dcor, they provide convenient control. I used the manual shade buttons on the EDU (the drive itself), and hit the open button - the shade then started to go back up about 10%, and then stopped. Lutron’s Pico is a wireless, battery powered (10-year battery life) device that delivers convenient control and flexible mounting options. A single Pico controller can operate one or multiple shades. So, if youre looking for window treatments that are stylish and functional, Back Bay Shutter Company is an open and shut case. The shade then quit responding.Īfter powering down the shade, and powering it back up, the shade would not respond to RA2 commands. The new Sivoia QS Wireless can be used to control Lutron roller shades, drapery tracks, skylight shades, and Roman shades wirelessly when paired with the new Pico wireless controller. Using a remote control, operate shades powered by intelligent motors with built-in antenna arrays. After activation, the shade started to move down with an RA2 command, and quit about 3/4 of the way down. Wireless (RTS) Controls Intelligent Wireless (RTS) Controls This motorized control system eliminates the need for wires. ![]() I have a QS wireless unit (non-battery powered) that when activated in RA2, went down about 1/4 of the way, and then stopped (almost like it stalled).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |